AS 4073-1993 pdf free

03-30 comment

AS 4073-1993 pdf free.Urea-formaldehyde foam thermal insulation – In situ set foam.
Urea-formaldehyde foam thermal insulation is produced on site and installed directly into buildings in a wet state. It dries over the following weeks. This Standard specifies the properties which such foam must meet if it is correctly formulated and produced.
The foam generated in the gun shall be fully expanded before placement in the building and, while mobile at the time of placement, sets within a specified time and then dries by diffusion and evaporation.
The properties of the set foam can he determined by this Standard on samples specially produced during placement operations at the building site.
AS 4073 specifies the properties of set urea-formaldehyde foam (set foam) made by using phosphoric acid as catalyst. and produced for herrnal insulation purposes.
3 PEFINITIONS For the purpose of this Standard, the definitions given in AS 1886 and AS 2352 apply.
4 MATERIALS Raw materials used to produce the set foam shall be tested as described in AS 4074 and when combined and reacted shall produce set foam to meet the requirements of Clauses 5. 6 and 7 of this Standard.
5 THERMAL RESISTANCE When tested at a mean temperature of 25°C in accordance with either AS 2464.5 or AS 24M.6, thermal conductivity shall he not greater than 0.036 W/m.K. The test specimen shall be obtained in a plastic bag from a sample produced from the injection gun at the building site, transported to the laboratory, conditioned at 23 ±2°C and a relative humidity of 50% for 4 weeks, then further dried at 40°C for 48 h and cut to the required size.
6 PROPERTIES OF SET FOAM Methods of determination and properties of the set foam shall inee the requirements in Table 1.
7 COMBUSTION CHARACTERISTICS When tested in accordance with AS 1530.3 the dry-set foam shall have the following indices:
(a) Spread of flame: not greater than 7.
(b) Smoke developed: not greater than 7.
The specimen for testing shall be 50 mm thick and shall be produced as in Clause 5.AS 4073 pdf download.

Download It Now Download Here
ATTENTION: I REALLY NEED YOUR SUPPORT.THANKS A LOT.
AS NZS 60598.2.17:2019 AS pdf free download

AS NZS 60598.2.17:2019

AS NZS 60598.2.17:2019 pdf free.Luminaires Part 2.17: Particular requirements—Luminaires for stage lighting, television and film studios (outdoor and indoor). 17.7.2 The luminaires for certain types of high-intensity discharge lamp, where an explosion risk is declared by the lamp manufacturer, shall incorporate a device to prevent immediate access to the lamp after switching-off or shall be marked in accordance with the...
Download
AS NZS 4859.1:2018 AS pdf free download

AS NZS 4859.1:2018

AS NZS 4859.1:2018 pdf free.Thermal insulation materials for buildings Part 1: General criteria and technical provisions. 2.1 GENERAL This Section provides performance criteria and technical provisions for materials to be used in the thermal insulation of buildings and building services. In addition to this Section the insulating material shall— (a) meet packaging and labelling requirements of Section 3; (b) where...
Download
AS NZS 2442.2:2021 AS pdf free download

AS NZS 2442.2:2021

AS NZS 2442.2:2021 pdf free.Performance of household electrical appliances一Rotary clothes dryers Part 2: Energy efficiency labelling requirements. Section 2 Test requirements, calculations and algorithms for the energy rating label 2.1 General This Section sets out the test requirements, equations and procedures br calculating values of the comparative energy consumption (CEC), and star rating, which appear on an energy rating label....
Download

LEAVE A REPLY

Anonymous netizen Fill in information