AS NZS 62841.2.10:2018 pdf free.Electric motor-operated hand-held tools, transportable tools and lawn and garden machinery- Safety Part 2.10: Particular requirements for hand-held drills mixers.
19.6 This subclause is not applicable.
19.101 For mixers with more than one spindle, the spindles shall be adequately spaced in order to reduce the risk of entanglement. The minimal clearance c between rotating parts in the area of the spindle outputs and along further 100 mm down to the mixer basket shall be at least 40 mm, see Figure 103.
Compliance is checked by measurement.
19.102 Chuck keys shall be so designed that they drop easily out of position when released. This requirement does not exclude the provision of clips for holding the key in place when not in use; metal clips fixed to the flexible cable or cord are not allowed.
Compliance is checked by inspect ion and by manual test.
The key is inserted in the chuck and, without tightening, the tool is turned such that the key is
facing down. The key shall fall out.
20 Mechanical strength
This clause of Part 1 is applicable, except as follows:
20.3.1 Replacement:
Mixers are subjected to three impacts that result from the tool being tipped over to strike a concrete surface. The tool is tipped with the longest mixer basket, including extensions, if applicable, recommended by the manufacturer in accordance with 8.14.2 a) 101). If no length of the recommended mixer basket is specified, the tip test is performed with a mixer basket of I m length. The tool is positioned in an upright position with the tip of the mixer basket resting on the concrete surface. The tool is then tipped in three different directions on to the concrete surface.
NOTE Typical mixer baskets have a length of 600 mm. Available extensions have a length up to 400 mm.
if attachments are provided as specified in accordance with 8.14.2, the test is repeated with each attachment or combination of attachments mounted to a separate tool sample.
20.5 This subclause is not applicable.
21 Construction
This clause of Part 1 is applicable, except as follows:
21.18.1.1 Addition:
A power switch lock-on device, if any, shall be located such that it can be activated without releasing any hand from the grasping area of the handles required in 19.4. In addition, it shall be so designed that it is not likely to be unintentionally locked on by the user’s hand.
Compliance is checked by inspect ion or, for a power switch with a lock-on device within the grasping area, by the following test.
With the power switch in the “on” position, the lock-on device shall not be actuated by a straight edge 25 mm long when the straight edge is pushed down on the lock-on device. The straight edge shall be oriented in any direction and be applied to bridge the surface of the lock-on device and any surface adjacent to the lock-on device.AS NZS 62841.2.10 pdf download.