BS EN 2320:2019 pdf free.Aerospace series – Aluminium alloy 2024-T4- Drawn bar- a≤75 mm.
BS EN 2320 This document specifies the requirements relating to: Aluminium alloy 2024-T4 Drawn bars a≤75mm for aerospace applications.The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 2004-1, Aerospace series 一Test methods for aluminium and aluminium alloy products 一Part 1: Determination of electrical conductivity of wrought aluminium alloy products EN 2044, Aerospace series – Round bars, drawn in aluminium and aluminium alloys一Tolerance class h11 – Diameter 4 mm≤D≤63 mm – – Dimensions EN 2045, Aerospace series – Square bars, drawn in aluminium and aluminium alloys一Tolerance class h11一Thickness 6 mm≤a≤50 mm一- Dimensions EN 2046, Aerospace series一Hexagonal bars, drawn in aluminium and aluminium alloys一Tolerance class h11一Width across flats 7 mm≤a≤50 mm – Dimensions  EN 2070-1, Aerospace series- Aluminium and aluminium alloy wrought products Technical specification一Part 1: General requirements EN 2070-3, Aerospace series 一Aluminium and aluminium alloy wrought products 一Technical specification- Part 3: Bar and section EN 4258, Aerospace series一Metallic materials 一General organization of standardization – Links between types of EN standards and their use EN 4500-003, Aerospace series 一Metallic materials一Rules for drafting and presentation of material standards一Part 003: Specific rules for heat resisting alloys.No terms and definitions are listed in this document. ISO and IEC maintain terminological databases for use in standardization at the following addresses: IEC Electropedia: available at http:/ /www.electropedia.org/ ISO Online browsing platform: available at http:/ /www.iso.org/ obp BS EN 2320 pdf download.