BS EN 54-5:2017 pdf free.Fire detection and fire alarm systems.Heat detectors – Point heat detectors.
BS EN 54-5 This European Standard specifies the requirements, test methods and performance criteria for point heat detectors intended for use in fire detection and fire alarm systems installed in and around buildings (see EN 54-1:2011). This European Standard provides for the assessment of verification of consistency of performance ([AVCP) of point heat detectors to this EN. For other types of heat detector, or for detectors intended for use in other environments, this standard should only be used for guidance. Heat detectors with special characteristics and developed for specific risks are not covered by this standard.The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 54-1:2011, Fire detection and fire alarm systems – Part 1: Introduction EN 50130-4:2011, Alarm systems – Part 4: Electromagnetic compatibility – Product family standard: Immunity requirements for components of fire, intruder, hold up, CCTV, access control and social alarm systems EN 60068-1:1994, Environmental testing . Part 1: General and guidance (IEC 60068-1:1988) EN 60068-2-1:2007, Environmental testing . Part 2-1: Tests – Test A: Cold (IEC 60068-2-1:2007) EN 60068-2-2:2007, Environmental testing – Part 2-2: Tests . Test B: Dry heat (IEC 60068-2- 2:2007) EN 60068-2-6:2008, Environmental testing – Part 2-6: Tests – Test Fc: Vibration (sinusoidal) (IEC 60068-2-6:2008) EN 60068-2-27:2009, Environmental testing . Part 2-27: Tests . Test Ea and guidance: Shock (IEC 60068-2-27:2009) EN 60068-2-30:2005, Environmental testing – Part 2-30: Tests – Test Db: Damp heat, cyclic(12h + 12 h cycle) (IEC 60068-2-30:2005) EN 60068-2-42:2003, Environmental testing – Part 2-42: Tests . Test Kc: Sulphur dioxide test for contacts and connections (IEC 60068-2-42:2003) EN 60068-2-78:2013, Environmental testing – Part 2-78: Tests – Test Cab: Damp heat, steady state (IEC 60068-2-78:2012) ISO 209:2007, Aluminium and aluminium alloys一Chemical composition.The heat sensitive element(s) or at least part of it, except elements with auxiliary functions (e.g. characteristic correctors), shall be at a distance≥15 mm from the mounting surface of the point heat detector. To confirm this, the point heat detector shall be tested in accordance with 5.2.1.  BS EN 54-5 pdf download.