BS EN 6056:2019 pdf free.Aerospace series – Rod-end with bearing per EN 4614 with self lubricating liner in corrosion resisting steel with external threaded shank – Dimensions and loads – Inch series.
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 2068, Aerospace series 一Rod ends with self-lubricating, self-aligning bearings 一Technical specification EN 2133, Aerospace series 一Cadmium plating of steels with specified tensile strength≤1 450 MPa, copper, copper alloys and nickel alloys EN 2424, Aerospace series一Marking of aerospace products EN 4614, Aerospace series一Spherical plain bearing in corrosion resisting steel with self-lubricating liner, wide series一Dimensions and loads一Inch series ISO 1132-1, Rolling bearings一Tolerances 一Part 1: Terms and definitions ISO 3161, Aerospace一UN] threads一General requirements and limit dimensions ISO 3353- 1, Aerospace – Lead and runout threads一Part 1: Rolled external threads ISO 3353-2, Aerospace一Lead and runout threads一Part 2: Internal threads ISO 8074, Aerospace一Surface treatment of austenitic stainless steel parts NAS 559, Lock-rod end (key type)1 SAE AMS 5643, Steel, corrosion resistant, bars wire, forgings, tubing and rings 16Cr-4.0Ni-0.30(Cb+ Ta)-4.0Cu solution heat treated, precipitation hardenable TR 4475, Bearings and mechanical transmissions for airframe applications一Vocabulary.For the purposes of this document, the terms and definitions given in TR 4475 apply. ISO and IEC maintain terminological databases for use in standardization at the following addresses: ISO Online browsing platform: available at http://www.iso.org/obp  IEC Electropedia: available at http://www.electropedia.org/ Symbols of limit deviations are in accordance with definitions ofISO 1132-1.  4 Requirements 4.1 Configuration, dimensions, tolerances and mass Configuration, dimensions, tolerances and mass shall be according to Figure 1 and Table 1 Table 1: Dimensions and tolerances are expressed in millimetres (inches). Figure 1: Dimensions and tolerances for Ra max. are expressed in μm (uin). Values apply after surface treatment. 4.2 Surface roughness Surface roughness shall be according to Figure 1. Surface roughness is measured before surface treatment.BS EN 6056 pdf download.