BS EN 6097:2019 pdf free.Aerospace series – Bearing, spherical plain, metal to metal, extra wide inner ring in corrosion resisting steel – Dimensions and loads – Inch series.
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 2030，Aerospace series 一 Steel X105CrMo17 (1.3544)一Hardened and tempered 一 Bars一 Des150mm EN 2133, Aerospace series 一Cadmium plating of steels with specified tensile strength S 1450 MPa, copper, copper alloys and nickel alloys EN 2337, Aerospace series一Spherical plain bearings一Technical Specification EN 2424, Aerospace series一Marking of aerospace products EN 3161, Aerospace series- Steel FE-PM3801 (X5CrNiCu17-4)- – Air melted, solution treated and precipitation treated, bar a or D S 200 mm, Rm 2 930 MPa ISO 1132-1, Rolling bearings一Tolerances 一Part 1: Terms and definitions ISO 8075, Aerospace一Surface treatment of hardenable stainless steel parts MIL-PRF-23827, Grease, aircraft and instrument, gear and actuator screw, NATO code No.G-354 metric1 MIL-PRF-46010, Lubricant, solid film, heat cured, corrosion – inhibiting, NATO Code-S-17381 MIL-PRF-81322, Grease, aircraft, general purpose, wide temperature range, NATO Code G-3951 TR 4475, Aerospace series 一Bearings and mechanical transmissions for airframe applications 一 Vocabulary.4.1 Configuration, dimensions, tolerances and mass Configuration, dimensions, tolerances and mass shall be according to Figure 1 to Figure 5 and Table 1. Table 1 and Table 3: Dimensions and tolerances are expressed in millimeters (inches). Figure 1 and Figure 2: Dimensions and tolerances for Ra max. are expressed in um (uin). Values apply after to surface treatment. 4.2 Surface roughness Surface roughness shall be according to Figure 1 and Figure 2. Values in micrometer (micro inches), apply prior to surface treatment. Surface roughness is measured before surface treatment.Surface treatment shall be as defined in chapter 5 (designation) with following codes: code T: Surface treatment according to ISO 8075 for inner ring before swaging; outer ring: no treatment;code P: Surface treatment according to ISO 8075 for inner ring before swaging; cadmium plating of outer ring according to EN 2133, 5 um to 8 um (200 pin to 300 puin).BS EN 6097 pdf download.