BS EN ISO 9453:2020 pdf free.Soft solder alloys – Chemical compositions and forms.
BS EN ISO 9453 This document specifies the requirements for chemical composition for soft solder alloys containing two or more of: tin, lead, antimony, copper, silver, bismuth, zinc, indium and/or cadmium.An indication of the forms generally available is also included.There are no normative references in this document.For the purposes of this document, the following terms and definitions apply.ISO and IEC maintain terminological databases for use in tandardization at the following addresses:ISO Online browsing platform: available at https://www.iso.org/obp 一IEC Electropedia: available at ttp://www.electropedia.org/3.1 soft solder metallic filler material which is used to join metallic parts and which has a melting temperature (liquidus) lower than that of the parts to be joined and, usually, lower than 450 °C and which wets the parent metals 3.2 batch collection of one or more units of product, made in a single production operation.Soft solders conforming to this document shall be supplied in one of the following forms: ingot, slab,stick, bar, rod, wire, pellets, preforms, spheres, ribbons, powder or pastes and creams containing powder. Solder shall be uniform in quality and free from detrimental conditions such as contamination or surface oxide that prevent melting and flow in a manner suitable for the intended application.NOTE 1.Solders supplied in the form of rod, wire, or preforms can be supplied with or without an integral flux,subject to agreement between the supplier and the purchaser.NOTE 2 Not all the solder compositions given in the tables are necessarily available in all the productforms listed.Each batch of solder supplied in accordance with this document shall be marked with the information indicated by a cross in Table 4. The information in Table 4 shall be applied to the product forms as follows: a) for ingots and slabs: by stamping, or inkjet marking on the surface of each unit of product;b) for sticks, bars, rods and wire in coil: either on a label securely attached to each unit of product, or on a label on the package in which the units of product are contained; c) for wire or ribbon on reels: on a label on each reel; d) for pellets, performs, spheres, powder, paste or cream: on a label on each individually packaged quantity;e) all applicable health and safety markings including lead free marking or lead containing marking;f) any other information which may be pertinent to the particular solder form.BS EN ISO 9453 pdf download.