BS ISO 23044:2020 pdf free

05-09 comment

BS ISO 23044:2020 pdf free.Guidelines for softening and desalination of industrial wastewater for reuse.
BS ISO 23044 Water quality indicators should include TSS, TOC, COD, pH,temperature, TDS, the species and concentrations of ions.The product water from wastewater softening and desalination processes is recommended to be reused for urban non-potable water, environmental water, and as pure or ultrapure water for cooling water,boiler feed water, process water, rinse water, and so on[4]. The process selection of wastewater softening and desalination processes should be determined after technical and economic comparison based on factors such as influent quality, product quality, quantity requirements, site conditions and environmental protection requirements.The wastewater needs to be pre-treated if necessary, before being fed into softening and desalination devices.The selection of pre-treatment process should consider the quality of wastewater, influent quality requirements for softening and desalination processes, water treatment volume and test data. Besides,the operational experience of similar projects should be referred, combined with local conditions. Finally, users can determine which technology to adopt through technical and economic comparison.Minimizing the discharge quantity of waste acid, waste alkali, waste residue and other harmful substances are important in the selection of softening and desalination processes or device. Measures for treating and disposing these wastes should be taken to meet the relevant environmental protection
requirements. Waste liquid (e.g., regeneration liquid of ion exchange resin process, concentrate of reverse osmosis process, etc.) disposed from the softening and desalination processes should be collected separately according to the characteristics of wastewater quality. Process flow diagram of industrial saline wastewater treatment for reuse is shown in Figure 1.Influent quality requirements for softening and desalination device are shown in Table 1. It is noted that data provided in this table is all in advisory typical ranges, which is suggested to be applied according to specific conditions, as well as the manufacturer’s specifications. The parameters listed in Table 1 are also illustrated as follows to show its effect on softening and desalination devices.BS ISO 23044 pdf download.

Download It Now Download Here
ATTENTION: I REALLY NEED YOUR SUPPORT.THANKS A LOT.
BS ISO 24081:2021 pdf download BS pdf free download

BS ISO 24081:2021 pdf download

BS ISO 24081:2021 pdf download.Ground cassava leaves (Isombe) — Specification. 1 Scope This document specifies requirements and methods of sampling and testing for ground cassava leaves, which are obtained from the processing of fresh cassava leaves (Manihot esculenta Crantz or Manihot glaziovii) intended for human consumption. 2 Normative references The following documents are referred to in the text in such...
Download

BS EN 1463‑2:2021

BS EN 1463‑2:2021 pdf download.Road marking materials — Retroreflecting road studs Part 2: Road test performance specifications. 4 Test sites and conditions 4.1 General Test sites shall be arranged at suitable locations that meet at least the requirements of 4.2 to 4.5. The test results will depend on the weather, traffic and road surface conditions. These shall all be described...
Download
BS ISO 3739‑2:2021 pdf download BS pdf free download

BS ISO 3739‑2:2021 pdf download

BS ISO 3739‑2:2021 pdf download.Industrial tyres and rims Part 2: Pneumatic tyres (metric series) on 5 degrees tapered or flat base rims — Load ratings. 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited...
Download

LEAVE A REPLY

Anonymous netizen Fill in information