BS ISO 3669:2020 pdf free.Vacuum technology – Dimensions of knife-edge flanges.
BS ISO 3669 This document specifies the dimensions of fixed or rotatable bolted knife- edge flanges used in vacuum systems for pressures ranging from atmospheric to as low as 10-11 Pa.
There are no normative references in this document.For the purposes of this document, the following terms and definitions apply. ISO and IEC maintain terminological databases for use in standardization at the following addresses:一ISO Online browsing platform: available at http://www.iso.org/obp一IEC Electropedia: available at http://www.electropedia.org/3.1 knife-edge flange metal sealed flange used for high and ultra-high vacuum service Note 1 to entry: Sandwiching one metal gasket between two knife- edge flanges and securely bolting these together makes a vacuum tight joint. The seal is made when the identical circular (triangular profile) knife-edges are bolted together. A deformable metal gasket captured between the knife-edge flanges establishes the sealing surface. Note 2 to entry: Originally developed as ConFlat@ flanges. The widespread and continued use of knife-edge flanges has made these a de facto international standard, codified by this document.3.2 nominal bore value intended to both identify the flange and specify the largest practical size of tubing that can be accommodated by the flange Note 1 to entry: See Table 1, in which the convention of identifying original flanges by the outside diameter of the flange (historically in inches) has been maintained.3.3 leak check groove groove machined into the seal side of the flange to facilitate the free passage of trace gas from the outer perimeter of the flange to the seal zone near the metal gasket.The selection of the material shall be compatible with the requirements for the flanges. Considerations may include service temperature, sealing capacity, corrosion resistance, magnetic permeability, type of
seal gasket used and dimensions. NOTE Austenitic stainless steel is commonly used, but it is not the intent of this document to specify or limit the choice of flange material to austenitic stainless steel.BS ISO 3669 pdf download.