DIN EN 4693:2018 pdf free.Aerospace series -Tie rod with integrated bolts -Assembly code A, B and C.
3 Requirements
3.1 Configuration, dimensions, tolerances and masses 3.1.1 Configuration The configuration shall be in accordance with Figure 1, Figure 2 and Figure 3. 3.1.2 Dimensions, tolerances and masses Dimensions are in millimetres, tolerances and masses in accordance to Table 4, Table 5, Table 6, Table 7 and Table 8. General tolerances shall be in accordance to ISO 2768-mK. Missing dimensions are manufacturing options. Assembly code definitions Assembly code A, B and C are shown in Figure 1, Figure 2 and Figure 3. For assembly code A, B and C:d1 = 20 mm and adjustable range for L1=土12,7 mm.
6 Locking clips
Locking clip according EN 4692. Description: For the fork ends there are two different types of safety clip.  For the eye end only one locking clip type A is available. Type A has only the function to fix the fork end, eye end against rotation, see Figure 4 and Figure 5.
Type B also has the function to fix the fork end against rotation, see Figure 6 and Figure 7. The second function is the load transmission of tension and compression forces. No separate pin required. The locking clip B is available in right hand (RH) and left hand (LH) version. Because this standard is not anymore in the document. Because there was a mistake in the selection of the surface treatment of the rod body. No parts were qualified with the previous surface treatment. Correction of a typing error. Because there was a mistake in the selection of the surface treatment of the rod body. No parts were qualified with the previous surface treatment.
DIN EN 4693 pdf download.