AS pdf free download - Page 11 of 51

AS 62054.21:2018 pdf free

AS 62054.21:2018 pdf free.Electricity metering (AC)-Tariff and load control Part 21: Particular requirements for time switches (IEC 62054-21:2017 (ED.1.1), MOD). 7.5 Functional requirements and tests — accuracy 7.5.1 Time setting and programming 7.5.1.1 Time switches with mechanical analogue dials On a day dial, it shall be possible to set the time with an accuracy better than ±7,5 mm. It shall...

09-07

Download

AS 3583.6:2018 pdf free – Determination of relative water requirement and strength index

AS 3583.6:2018 pdf free.Methods of test for supplementary cementitious materials Method 6: Determination of relative water requirement and strength index. 3 DEFINITIONS For the purpose of this Standard the definitions given below apply. 3.1 Control mortar A mortar prepared using a selected General Purpose cement without addition of supplementary cementitious material. 3.2 Test mortar A mortar prepared using a mixture...

09-07

Download

AS 62054.11:2018 pdf download

AS 62054.11:2018 pdf download.Electricity metering equipment (a.c.)—Tariff and load control Part 11: Particular requirements for electronic ripple control receivers (IEC 62054-11:2004 (ED.1.1), MOD). If the bursts are applied while the receiver is in a quiescent state, it shall be verified that the receiver does not start as an effect of the bursts. For this purpose, 3 s after the bursts...

09-07

Download

AS NZS 60335.2.82:2018 pdf free – Particular requirements for amusement machines and personal service machines

AS NZS 60335.2.82:2018 pdf free.Household and similar electrical appliances- Safety Part 2.82: Particular requirements for amusement machines and personal service machines. 4 General requirement This clause of Part 1 is applicable. 5 General conditions for the tests This clause of Part us applicable except as follows. 5.6 Replacement: Controls or switching devices in the user area are adjusted to the...

09-07

Download

AS NZS 2885.0:2018 pdf free

AS NZS 2885.0:2018 pdf free.Pipelines- Gas and liquid petroleum Part 0: General requirements. 13 Basis of the AS(/NZS) 2885 series The objective of the AS(/NZS) 2885 series is to provide requirements for the safe design, construction, operation and maintenance of PIPELINE SYSTEMS that carry petroleum fluids. The AS(/NZS) 2885 series is a single and sufficient technical standard that provides an...

09-07

Download

AS 7240.12:2018 pdf free – Line type smoke detectors using a transmitted optical beam

AS 7240.12:2018 pdf free.Fire detection and alarm systems Part 12: Line type smoke detectors using a transmitted optical beam. 4.4.2 If there are cables connecting separate parts of the detector, then a means shall be provided for a remote monitoring system (e.g. the fire detection control and indicating equipment) to detect a short or open circuit on those cables, in...

09-07

Download

AS NZS 3733:2018 Textile floor coverings—Cleaning ma intenance of res idential and commercial carpeting

AS NZS 3733:2018 pdf free.Textile floor coverings—Cleaning ma intenance of res idential and commercial carpeting. 2.1 PLANNING A MAINTENANCE PROGRAM A maintenance program should be established at the time of the development and completion of the textile floor covering specification. Just as specifications have to be concerned with traffic volume and soiling rates, so too does the maintenance program. For...

09-07

Download

SAE AS 5276-1:2019 pdf free

SAE AS 5276-1:2019 pdf free.Performance Standard for Child Restraint Systems in Transport Category Airplanes. 2.5 Compatibility of a CRS to Size of Child Occupant: The CRS and its integral restraints shall be designed to be compatible with accepted classification standards, as indicated in 2.3 and 2.4, for the protection of children under high dynamic loads. a. Any child with a...

09-07

Download

AS NZS 62841.2.10:2018 pdf free – Particular requirements for hand-held drills mixers

AS NZS 62841.2.10:2018 pdf free.Electric motor-operated hand-held tools, transportable tools and lawn and garden machinery- Safety Part 2.10: Particular requirements for hand-held drills mixers. 19.6 This subclause is not applicable. 19.101 For mixers with more than one spindle, the spindles shall be adequately spaced in order to reduce the risk of entanglement. The minimal clearance c between rotating parts in...

09-07

Download

AS 1603.13:2018 pdf download – Duct sampling smoke detectors

AS 1603.13:2018 pdf download.Automatic fire detection and alarm systems Part 13: Duct sampling smoke detectors. 3.2 Electrical requirements 3.2.1 Electrical safety Where the maximum working voltage exceeds extra-low voltage (ELy), the DSE shall conform with the appropriate requirements of AS/NZS 3100. 3.3 Connecting facilities The means of connection shall not permit disconnection of the DSE or its associated detector without...

09-07

Download