IEEE 1277-2000 pdf free

04-29 comment

IEEE 1277-2000 pdf free.IEEE Standard General Requirements and Test Code for Dry-Type and Oil-Immersed Smoothing Reactors for DC Power Transmission.
Abstract: The electrical, mechanical, and physical requirements of oil-immersed and dry-type air core smoothing reactors for high-voltage direct current( HVDC)applications are specified. Test code is defined and appropriate technical background information is presented or identified.
Keywords: construction, dry-type air core, HVDC, oil-immersed, rating, smoothing reactors, test code application.
This standard applies only to oil-immersed and dry-type smoothing reactors for dc transmission. It does not apply to other smoothing reactors such as reactors for power converters for variable speed drives, etc
2. References
ANSI C68.3-1976. American National Standard Recommended Practice for the Detection and Measurement of Partial Discharges(Corona)During Dielectric Tests.
ANSI S1.4-1983, American National Standard Specification for Sound Level Meters.
ANSI/ASME Bl 1-1989, American National Standard Unified Inch Screw Threads (UN and UNR Thread Forms).
ANSI/ASME Bl. la-1984, Unified Inch Screw Threads (UN and UNR Thread Form)Supplement to ANSIB1.1-1982.
ANSI/ASME B1. 20.1-1983, Pipe Threads General Purpose (Inch).
3.2 ineremental inductance: The incremental inductance of a smoothing reactor is the inductance of the smoothing reactor, in Henries, determined on the basis of a small current increase (or decrease )at a pre defined dc current. The incremental inductance is. therefore. defined as a function of dc current from the minimum current up to the maximum peak short-circuit current.
3.3 rated dc current: The rated dc current of a smoothing reactor is the maximum continuous dc current at rated conditions.
3.4 rated de voltage: The rated dc voltage of a smoothing reactor is the maximum continuous de voltage pole to ground, that will be experienced by the smoothing reactor.
3.5 ripple current: The total harmonic current content superimposed on the de current For specific engi neering purposes, it is essential to define the harmonic spectrum of the ripple current in terms of amplitude and frequency. For general purposes, the ripple current can be expressed as the root-mean-square(rms)value of the harmonic current at any level of dc current: including the continuous rated dc current.
3.6 ambient temperature; The ambient temperature is the temperature of the cooling air surrounding a smoothing reactor.IEEE 1277 pdf download.

Download It Now Download Here

IEEE 82-2002 pdf free

IEEE 82-2002 pdf free.IEEE Standard Test Procedure for Impulse Voltage Tests on Insulated Conductors. Insulated conductors in service are subjected to voltage surges from lightning. switching, and other sources. These surges vary widely in wave shape, magnitude. and frequency of occurrence. Laboratory tests cannot duplicate the wide variety of surges met in service. Standard test procedures. however, make it possible...

IEEE 475-2000 pdf free

IEEE 475-2000 pdf free.IEEE Standard Measurement Procedure for Field Disturbance Sensors 300 MHz to 40 GHz. Abstract: Test procedures for microwave field disturbance sensors to measure radio frequency RF) radiated field strength of the fundamental frequency, harmonic frequencies, near field power flux density, and nonharmonic spurious emissions of sensors operating within the frequency range of 300 MHz to 40 GHz...

IEEE 111-2000 pdf download free

IEEE 111-2000 pdf download free.IEEE Standard for Wide-Band (Greater Than 1 Decade) Transformers. Abstract: Electronics wide-band transformers transmitting power within a wide band of frequencies covering typically at least one decade in the frequency spectrum are covered in this standard Keywords: Balance test, balun, communication transformer, data transformer, harmonic distortion impedance, insertion loss, matching transformers, return loss, transformer, video transformer...


Anonymous netizen Fill in information